Guide · Homeowners · 4 min read · Updated 17 November 2026
How Thick Should a Concrete Base Be? Sheds, Garden Rooms and More
Short answer
A typical shed base is around 75–100mm of concrete on 75–100mm of compacted hardcore. Garden rooms usually need 100–150mm, often reinforced with steel mesh. Hot tub bases are commonly 100–150mm reinforced, and garage slabs 100–150mm with thickened edges. Always follow the building or hot tub supplier's specification, because it overrides general guidance and may affect your warranty.
Recommended thickness by use
The right thickness depends on the weight of the building, how that weight is spread and the ground underneath. A light timber shed spreads its load over a floor frame, so a thin slab is fine on good ground. A hot tub puts a heavy, concentrated load on a small area. A garage carries a car and often has heavy concrete wall panels sitting on the slab edges, which is why the edges are commonly thickened.
The figures below are typical for domestic work on firm, well-drained ground. Clay that shrinks and swells, made-up ground, or a site near trees can need a deeper sub-base or a thicker, more heavily reinforced slab.
| Use | Concrete thickness | Hardcore sub-base | Reinforcement |
|---|---|---|---|
| Small shed or log store | 75–100mm | 75–100mm | Usually none |
| Large shed or summerhouse | 100mm | 100mm | Optional mesh |
| Garden room or office | 100–150mm | 100–150mm | Steel mesh common |
| Hot tub | 100–150mm | 100–150mm | Steel mesh |
| Single garage or workshop | 100–150mm with thickened edges | 150mm or more | Steel mesh |
| Heat pump or oil tank pad | 75–100mm | 75–100mm | Usually none |
The layers of a proper concrete base
A concrete base is more than a layer of concrete on soil. Each layer does a job, and skipping one is the usual reason a slab cracks or sinks. The topsoil is removed completely, because it is soft and full of organic matter that rots and settles. The formation level, the firm ground underneath, is then levelled and compacted.
Crushed stone sub-base, commonly called MOT Type 1 or hardcore, is laid in layers and compacted with a plate compactor. On top goes a thin sand blinding layer to protect the membrane, then a damp-proof membrane, then steel mesh on spacers if specified, and finally the concrete.
- Topsoil and turf removed down to firm ground
- Formation compacted and levelled
- Hardcore sub-base laid and compacted in layers
- Sand blinding to protect the membrane from sharp stones
- Polythene damp-proof membrane, lapped and taped at joins
- Steel mesh on chairs so it sits within the slab, if specified
- Concrete poured, compacted and finished level
Steel mesh and thickened edges
Concrete is strong in compression but weak in tension, so it cracks if the ground moves or a load bends the slab. Steel mesh held within the concrete helps control those cracks and spread loads. For garden rooms, hot tubs and garages, A142 or A193 mesh is commonly specified, the number referring to the cross-sectional area of steel per metre. The mesh must sit on plastic chairs so it ends up inside the concrete, not at the bottom.
Thickened edges are a deeper strip of concrete around the perimeter of a slab. They support heavy wall panels on sectional garages and stop the edge cracking under load. The supplier's drawing will show the size required.
Size, level and finish
Many shed and garden room makers recommend a base the same size as the building footprint, or very slightly smaller, so rain running off the walls drips onto the ground rather than pooling on the slab and soaking the bottom rail. A base that sticks out well beyond the walls can draw water back under the building.
The slab should be level for most buildings. Garden room suppliers often give a tolerance of a few millimetres across the base, and hot tubs must be dead level so the water line sits evenly. A tamped finish suits a base hidden under a building; a smoother float finish suits pads that stay on show.
Concrete strength and mixes
Concrete strength is described by classes set out in BS 8500, the British Standard commonly used to specify concrete in the UK. For domestic bases, ready-mix suppliers will recommend a suitable standard or designated mix for the use, with stronger mixes for garages and anything exposed to frost and de-icing salts. Your installer should know which to order.
Small pads are often mixed on site with a mixer using cement, sand and aggregate. Larger slabs use ready-mix delivered by lorry, which gives a consistent strength and can be poured in one go so there are no weak joints between batches.
How long before you can build on it?
Concrete keeps gaining strength for weeks after it is poured. In normal UK weather, a slab can usually be walked on carefully after a day or two, and a light timber shed is often put up after about a week. Heavier buildings, garages and hot tubs are best left longer, and concrete reaches its specified design strength at around 28 days. In cold weather everything slows down, and concrete must be protected from frost while it is young.
In hot or windy weather the surface can dry too quickly and crack, so installers cover slabs or keep them damp for the first few days.
Signs a base was built too thin
An undersized base usually gives itself away within a year or two. Cracks running right through the slab, corners that have dropped, or a building whose doors start sticking are the common signs. Under hot tubs, a slab that has settled unevenly leaves the water line visibly higher at one end. Thin concrete laid straight onto soil without a sub-base is the most frequent culprit, followed by bases poured over old tree roots that later rotted away.
Repairs are rarely worthwhile. Breaking out and replacing an old shed-sized base starts from around £300 before the new slab, so getting the thickness right first time is the cheaper route.
Questions people also ask
Is 50mm of concrete enough for a shed base?
50mm is too thin for most shed bases. It cracks easily, especially on softer ground or under point loads such as a lawnmower being wheeled in. Around 75–100mm of concrete on 75–100mm of compacted hardcore is the usual standard for a garden shed.
Does a shed base need steel mesh?
Most small shed bases on firm ground do not need mesh. Larger sheds, workshops with heavy machinery, garden rooms, hot tubs and garages commonly use A142 or A193 mesh to control cracking and spread load. Follow the building supplier's specification if it gives one.
Do I need a damp-proof membrane under a concrete base?
A polythene damp-proof membrane is strongly recommended under bases for garden rooms, offices and anything you want to keep dry. It stops ground moisture rising through the concrete and also stops water being drawn out of the fresh concrete into the hardcore while it cures.
Written and checked by the Concrete Base Installation team. Read our editorial policy.
More guides
How Much Does a Concrete Base Cost in the UK?
A professionally laid concrete shed base up to 3m by 2.4m typically costs £450–£850 in the UK. Garden room bases cost £70–£110 per square metre, hot…
Concrete Base vs Ground Screws vs Paving Slabs: Which Is Best?
A concrete base is the strongest and most versatile foundation for sheds, garden rooms, hot tubs and garages, costing £450–£850 for a typical shed…
Preparing for a Concrete Base: What Happens on the Day
Before a concrete base is laid, clear the area, confirm the building size and position, check for buried cables and pipes, and plan a route for…
What Base Does a Hot Tub Need? Requirements and Costs
Most hot tubs need a solid, flat, level base strong enough for the full weight when filled with water and people, which can be well over two tonnes.…
Get a free concrete base installation quote
Tell us what you need and we'll come back with a clear price.
Request a quote